Skip to main content

Operation and Calibration of UV Cabinet Advance

Before using ensure the validity of calibration. Switch on the power. Switch on the normal light and open the front door pulling towards the front side to keep the TLC plates. Place the TLC plate in UV chamber horizontally on the base of the chamber.
Switch on the particular nm wavelength light i.e. 254 nm or 365 nm light at which the TLC is to be viewed. Do not expose to UV light while handling the UV cabinet, use always normal light only while operations. Switch of the power after the completion of the test.
UV Cabinet, salicylate, Core Procedure, salicylate Operation and Calibration of UV Cabinet Advance



Comments

Popular posts from this blog

Preparation of barium chloride solution

Pour about 75 ml of Distilled water into a 250 ml capacity beaker. Weigh 10.0 grams of Barium Chloride LR and transfer slowly, into above said beaker, through it‘s side walls, while gentle mixing, by using a glass rod. Transfer prepared solution into a 100 ml volumetric flask, by using a glass funnel. Rinse the beaker and funnel with few ml of Distilled water, and allow to add into the contents of volumetric flask. Make up the volumetric flask to mark with Distilled water, remove the funnel, keep the lid to close the volumetric flask and shake gently to mix the solution. Transfer the prepared solution into a suitable container and label with all necessary details. The resultant solution is having the concentration of 10.0% w/v. Barium Chloride , Distilled water, Glass rod, Glass funnel, Calibrated Analytical Balance

Preparation of nitric acid dilute (10 percent)

Measure 10.6 ml of Nitric Acid LR and transfer into a 50.0 ml capacity beaker. Pour about 75.0 ml of distilled water into a 250 ml capacity beaker. Transfer slowly, through sidewalls of the beaker, 10.6 ml of Nitric Acid LR into above said beaker, while gentle mixing, by using a glass rod. Transfer prepared solution into a 100 ml volumetric flask by using a glass funnel. Rinse the beakers and funnel with few ml of distilled water , and allow to add into the contents of volumetric flask. Make up the volumetric flask to mark with distilled water, remove the funnel, keep the lid to close the volumetric flask and shake gently to mix the solution. Nitric Acid , Glass rod, Glass funnel, Beaker, Volumetric flask , Measuring cylinders

preparation of sodium hydroxide solution dilute

Pour about 75 ml of distilled water into a 250 ml capacity beaker. Weigh 5.0 grams of Sodium Hydroxide Pellets LR and transfer slowly, into above said beaker, through it‘s sidewalls, while gentle mixing by using a glass rod. Transfer prepared solution into a 100 ml volumetric flask by using a glass funnel. Rinse the beaker and funnel with few ml of distilled water, and allow to add into the contents of volumetric flask. Make up the volumetric flask to mark with distilled water, remove the funnel, keep the lid to close the volumetric flask and shake gently to mix the solution. Transfer the prepared solution into a suitable container and label with all necessary details. The resultant solution is having the concentration of 5.0% w/v. Sodium Hydroxide Pellets , glass funnel, sidewalls, glass rod