Operation Of Tapped Density Tester (Campbell Electronics C TDA 2)

The procedure is applicable for calibrating the Campbell make C-TDA-2 tapped density tester used at the Quality Control department. It is the responsibility of the Quality Control personnel involved in the operation of tapped density tester to follow the procedure and schedule as mentioned in this Standard Operating Procedure.
Check that the instrument is clean and free from dust, if not, clean with a soft cloth duster.
Density, Tester, cylinder Holder clean, Anvil

Comments

OFLOTAL - OR

Ofloxacin - 200mg + Orinidazole-500mg, Model of pack:10x10's, Packing:BlisterOfloxacin - 200mg + Orinidazole-500mg, OFLOTAL - OR TABLETS

Table of contents (toc) for republic of uzbekistan

Table of contents for dossier requirments (republic of uzbekistan). Toc for republic of uzbekistan , toc formate for dossier

Preparation of mercuric acetate solution 10 percent

Pour about 75 ml of Glacial Acetic Acid into a 250 ml capacity beaker. Weigh 10.0 grams of Mercuric Acetate LR and transfer slowly, into above-said beaker, though it‘s sidewalls, while gentle mixing by using a glass rod. Transfer prepared solution into a 100 ml volumetric flask, by using a glass funnel. Rinse the beaker and funnel with few ml of Glacial Acetic Acid, and allow to add into the contents of volumetric flask. Make up the volumetric flask to mark with Glacial Acetic Acid , remove the funnel, keep the lid to close the volumetric flask and shake gently to mix the solution. Transfer the prepared solution into a suitable container and label with all necessary details. The resultant solution is having the concentration of 10.0% w/v. Mercuric Acetate , Glacial Acetic Acid , Glass funnel, Volumetric flask

ICHAPPS

Search This Blog